Very Important Please Read
About Custom Straps
Custom order straps are non-returnable and non-refundable. Once they are made to your measurement they cannot be reused. Please make sure you measure your straps twice before placing your order. Carefully follow our instructions on measuring straps below to ensure your order is correct.
About Placing Your Order.
When measuring round to the closest 1/8”. DO NOT add or take away to your measurements as this will cause your straps to be too tight or too loose.
Please follow the exact measuring instructions. American Slings and Patio Supplies will do the necessary adjustments to the length once we receive your order.
The following pictures will guide your steps in how to measure your straps properly before submitting your order with AS&PS.
If our guidelines are not followed, it may cause your straps not to fit properly.
HOW TO MEASURE SINGLE WRAP STRAPS
Identifying if it’s a single wrap strap.
The single wrap strap is identified by the location of the holes.
They are located on the inside portion of the chair frame. Picture 1
Measuring the width of the Strap.
Using a flexible cloth or a plastic tape measure, measure the strap width. If it measures approximately 1 ¼”, order 1 ½”. If it measures approximately 1 ¾”, order 2”.
Measuring the Length of the Single Wrap Strap.
Measure the distance from the tip of the left frame (Picture 2) to the tip of the right frame (Picture 3). As we show in Picture 4.
HOW TO MEASURE DOUBLE WRAP STRAPS
Identifying if it’s a double wrap strap.
The double wrap straps are identified by the location of the holes.
They are located on the bottom portion of the chair frame. Picture 5
Measuring the length of the Double Wrap Strap.
Place measuring tape at center of the bottom hole on one side of the frame and wrap it around once and over the frame (Picture 6, 7, 8)
Measure all the length to the tip of other side of the frame (Picture 9, 10).